• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

NIRC. Chit Chat

neillarson said:
I would love to get a set for my wraith, the delrin ones I did with the compound curves drive me crazy. Any idea of cost?
Click to expand...

I was thinking about how I was going to bend them but, I could just copy my VP Titanium steering setup. I like the bends on those and they are simple and use rod ends. Cost will be little for you guys.
I'll get going on figuring it out and make a few sets. The Drag link is needed as well, i assume?

edit: actually, I might have to use 3/16" stainless for the wraith steering but, at that diameter it'll be better to go with an external thread like VP did with the Ti stuff.
 
Last edited:
Revo rod ends. I need some toe in...the Rock Rider is outa control w the tsl's/vxl! I swapped in the F'n Bastard 16/50 along with the RR trans gears :twisted:
 
I swear that these crawlers can be a bigger hole to dump money in than a boat.

- Tranny Bearings - $21
- Tranny Case - $10
- FKen VP Dig - $94
- Dig servo - $30
- new Body - $30
- new motor - $50

Anybody want to buy a Tekin Redline 13.5?
 
Last edited:
Cant make it sunday to much football and beer drinking to do that day,sat morning would work get a early start on the new tear:)
 
S ARR T 8 said:
Cant make it sunday to much football and beer drinking to do that day,sat morning would work get a early start on the new tear:)
Click to expand...

Bah.. its the worst weekend of football period, week 17 when no one plays. :) Besides, all the fantasy leagues should be done by now!
 
You must log in or register to reply here.
Back
Top