4 Link Set Up Instructions or Pic Details

[BMFOTP]

I am new to crawlers and need some help finding instructions on how to put a 4 link suspension on my Axial RTR. I have searched the fourm using 4 link and Axial and havent been able to find instructions on how to put the 4 link suspension system together. I have all the hardware I need I just am not sure where to put the spacers or how to set up the rear links so they dont rub against the shocks. I cant figure out how to get the upper links into position with the location of the servo. I have the plate that allows me to place the lower suspension on the inside of the frame, if that helps people with the information they are going to provide. If anyone has detailed instructions or a picture board showing how to put the 4 link system together I would appreciate your help with this situation. Thanks in advance.:?:

 

[constantmotion]

Maybe this will help you out

http://www.rccrawler.com/axialcompbuild.html

 

[BMFOTP]

Maybe this will help you out

http://www.rccrawler.com/axialcompbuild.html

Thanks. That post showed me where to put the rear links and that is what I needed to know concerning the links.

Should my rear links move side to side (they wiggle in their brace) and if so how much and if not how to I fix the problem?:?:

 

[BEELZEBOB]

check out the thread on squat vs. anti squat.

gives you the guideline to set your suspension and linkage up proper.


http://www.rccrawler.com/forum/showthread.php?t=54791

i had to read it 3 times before it all made sense