Best way to fix led wires to underside of body?

[BubbaEinstein]

I've been thinking tape or gobs of shoe goo. I'm sure there is a "standard" method for doing this but I haven't been able to find it....what works for you?

thanks!

 

[Mr.Joshua]

I hot glued mine

 

[War Pig]

Small square of servo tape over the wires.

 

[Joe&Jeep]

duck tape, which is a water proof duct tape, I completely submerge my AX10 and haven't had it come off yet.

 

[redjones]

Electrical tape then Plastic Dip

 

[pottymouth]

You were spot on with the shoo goo. Adhesive backed zip tie anchors work well, too, and are easier to rework later.

 

[mahgninnuc1]

Screws, nails, bailing wire, and sheet metal.

 

[sick86burban]

i used gorilla tape..which is basically waterproof if you lay it down good. its been through water,mus,snow u name it and still good.

 

[cherokee95]

I use aluminum tape...I also use it to back my LED's so they don't light up the inside of my body.

 

[ROCKEDUP RICKY]

Screws, nails, bailing wire, and sheet metal.

and gum.:ror:

 

[rmdesignworks]

I use aluminum tape...I also use it to back my LED's so they don't light up the inside of my body.

X2...works well for heat shielding too

 

[PhantomRS10]

I used hot glue on my wires and its held up just fine