Front bumper suggestion for Jeep Gladiator body

[Count0Interrupt]

I have the Pro-Line Jeep Gladiator body with a VS-4 front bumper. Obviously it sticks out quite a bit, so I'm looking for suggestions for bumpers that is far shorter/closer to the frame.

Something like ScalerFab Bull Bar but even closer to the frame.

 

[djr01974]

How about the stock bumper that comes on the trailwalker

 

[Count0Interrupt]

How about the stock bumper that comes on the trailwalker

That's one of the option on my list.

Would love to hear if there are others that people here have good experience with as well.

 

[Count0Interrupt]

For illustration, here's a side view:

 

[djr01974]

Here is the trailwalker bumper on my trailwalker with a hilux body.

 

[Count0Interrupt]

Yeah, that can be close enough.

 

[DukeMinnix]

I’d say any of the cheapy ebay bumpers that mount to the exterior of the frame rails would suit you nicely. Something like this

https://www.ebay.com/itm/164170870844

 

[Count0Interrupt]

I’d say any of the cheapy ebay bumpers that mount to the exterior of the frame rails would suit you nicely. Something like this

https://www.ebay.com/itm/164170870844

I saw someone on YouTube has that with a Jeep body and it sticks way out.

 

[Count0Interrupt]

I’d say any of the cheapy ebay bumpers that mount to the exterior of the frame rails would suit you nicely. Something like this

https://www.ebay.com/itm/164170870844

Would any SCX10 II bumpers work for Enduro too?

 

[djr01974]

Yes I fitted the blazer rear bumper on with no problems

 

[DukeMinnix]

I saw someone on YouTube has that with a Jeep body and it sticks way out.

I have similar from scalerfab on a g6 body and I drilled extra holes and have it mounted way back. If you’re willing to add some holes

 

[Count0Interrupt]

Ordered this Injora bumper from Amazon but it won't be here until May 6th.

I realized Pro-Line has its own bumper that would fit too since they use it in the body's picture. I may ended up getting those since it will accommodate a light bar easily.

 

[Count0Interrupt]

I ended up ordering the Yeah Racing bumper. The posts fits fine but the bumper still stick out a fair bit, not much of improvement from the VS4-10 bumper. So I remove the posts and just line up the bumper against the bumper mount, mark the holes, and drill two new holes in the top of the bumper. Now it sits flush! I need to get some longer screws and lock nuts to ensure firm fit.

VS4-10 bumper:

Yeah Racing with posts:

Yeah Racing with drilled holes: