• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

Internal Springs, where to get them

losikid

Got Worms?
Joined
Jun 23, 2009
Messages
6,112
Location
Golden, CO
Well i have taken all but a little weight out of my losi and now it is horrible side hilling, the rear is springing over. I'm running losi gold springs, softest spring i know of so 'm thinking going internal to get my softness and keeping my tires and links out of the springs. Where can i find internal springs with a similar or softer rate as the gold losi springs. I've been told to go down to the hardware store and get some but i'm not sure if those are the best choice
 
Sometimes you'll find them in the bins near the nuts and bolts if they aren't out in the open.
 
Ask someone, i found some in little pull out drawers.(by the nuts and bolts)
Do they have any that are equivalent or softer than losi golds Bill? and which Ace did you go to?

I really want to give internals a shot up front after my new servo horn and narrowed DH's get here and I can dial in all the steering that my rig has to offer.
 
Do they have any that are equivalent or softer than losi golds Bill? and which Ace did you go to?

I really want to give internals a shot up front after my new servo horn and narrowed DH's get here and I can dial in all the steering that my rig has to offer.

I dont think they were any softer than the gold,also they were smaller( like internal) springs. I didnt buy any, was just looking at them. They were all scattered in the drawers. If they restocked it would be a better selection. The ace is over by my house,on weston rd. You should check out the soft TCS internal springs. Call Richgarrett he might be able to show you the ones i sold him.
 
I use half a mechanical pencil spring. That and some 35wt oil. Just had to buy a few different pencils to get the correct diameter.
 
Back
Top