Mattzilla Tundra 1.9

[ROLANDROCKSHOP]

they are functional as they sit..

but they will be more functional when im done with it.
"thumbsup"

 

[eric113]

Last thing is a lightbar..and where to put it/them.
Either 1 big bar or 2 smaller ones..?
what do you guys think?

What about putting one light bar inside the cab ?

 

[n8welch]

You bu chance have a pic of how the exo cage mounts to the tundra body? Thats such a sick truck. One of my favorite rigs for sure.

N8's SG3 using Tapatalk Pro

 

[ROLANDROCKSHOP]

Ran up to Missouri to help Parker put on a Benefit Recon G6.

Had an awesome time...raised a good amount for the cause.

My Drivn diva was a bit rough on the Ol'tundra..

Didn't need that stinger anyway...:roll:

"thumbsup"

 

[JonnnScott]

Well thats one way to test the strength of your parts. lol

 

[Percymon]

just need running through a nice clean stream

 

[UPSrat]

it looks better without the stinger. just wield a tube across to fill the gap.

 

[ROLANDROCKSHOP]

<iframe width="640" height="360" src="//www.youtube.com/embed/eDhkwllIDlk" frameborder="0" allowfullscreen></iframe>

 

[ROLANDROCKSHOP]

Took the Tundra out to a local gtg comp..

Mud bog and sled pull

Took home 1st in the Mud bog 3-4 sec passes.:shock:

Would have taken 1st in sled pull but i didnt run the 3 times i was supposed to..and anothers total out did mine.:roll:

And took home the show n shine trophy.

Trophies..

video will be up this week.

 

[ROLANDROCKSHOP]

<iframe width="640" height="360" src="//www.youtube.com/embed/bugGIDjAlmA" frameborder="0" allowfullscreen></iframe>

 

[ROLANDROCKSHOP]

Thread update...

Tundra has been on a roadtrip...
Crawlapalooza..Oct 10th..competed in the scale comp and dash.
2nd course and last gate i broke a cvd..again.
Took a chance and blipped the throttle..cleared the gate and landed hard on front axle, snapping the axle and housing clean in two.

..then a Quick Parker pickup and were off to the Florida G6 Coven quest 18th-19th..and then back for the Arkansas G6 on the 25th.

What an Adventure!

 

[ROLANDROCKSHOP]

Scouting video...
<iframe width="640" height="360" src="//www.youtube.com/embed/zPP1eBjm6DI" frameborder="0" allowfullscreen></iframe>

 

[ROLANDROCKSHOP]

Well...
back to the work bench...

Snapped Another AXIAL cvd...:evil:

Tired of snapping pins and shafts...

The Tekin 13.5t w torq rotor just has an awful lot of grunt and snaps them like swizzle sticks.

Time for some REAL beef in the shaft...
Vanquish VVD's are going in.
SCX10 VVD V1-HD 4mm Stubs - Vanquish Products

 

[ROLANDROCKSHOP]

Fresh beef!!!!

Out with the wimpy...in with the meaty..

.
.
.
Now just need 4 more sets of vvd's to upgrade the rest of my scx fleet..:twisted: