mil stone wideners using rc4wd wagon wheels?

[lilws6]

Has anyone done this? I just spent probably ten minutes trying to get the wheel nuts on lol. Not sure if I can find a smaller headed barrel nut but I’m thinking these won’t work... [emoji853]

Sent from my iPhone using Tapatalk

 

[BIGW0RM]

Has anyone done this? I just spent probably ten minutes trying to get the wheel nuts on lol. Not sure if I can find a smaller headed barrel nut but I’m thinking these won’t work... [emoji853]

Sent from my iPhone using Tapatalk

The plastic wrench used for Mini Z's is thin enough to grab and tighten them down inbetween the lugs where it gets caught up. I randomly tried one I had and it worked when no other tool I tried would. Thats how I got my milstones on my RC4WD blackjack.

Thats how I got mine on. Mini Z wrench is shown at dead top of this picture.
https://i.ebayimg.com/images/g/I~AAAOSw-PFagQfw/s-l640.jpg

 

[lilws6]

The plastic wrench used for Mini Z's is thin enough to grab and tighten them down inbetween the lugs where it gets caught up. I randomly tried one I had and it worked when no other tool I tried would.

Thats how I got mine on. Mini Z wrench is shown at dead top of this picture.
https://i.ebayimg.com/images/g/I~AAAOSw-PFagQfw/s-l640.jpg

Hmmm thank you! Kinda wish I still had my mini z now [emoji1787]


Sent from my iPhone using Tapatalk

 

[BIGW0RM]

Hmmm thank you! Kinda wish I still had my mini z now [emoji1787]


Sent from my iPhone using Tapatalk

Yeah I got lucky! I spent almost 40 minutes trying all kinds of tools until I found that at the bottom of my RC junk drawer.

But it can be done. I just used some lock tight on them so they wouldnt come loose. They seemed to do that over a few packs until I did that.

Good luck man. "thumbsup"

 

[Short_Bus_Kustoms]

I used needle nose pliers for 30 minutes. It was a huge pita.

 

[lilws6]

I used needle nose pliers for 30 minutes. It was a huge pita.

That’s what I did for one of them and said forget it. I found a cheap set of small drivers I’m going to see if they work today. They look possibly small enough to clear.


Sent from my iPhone using Tapatalk

 

[Short_Bus_Kustoms]

They look good, but boy do they suck to tighten.

 

[lilws6]

These are what I found on eBay. I did have to sand the end but now it fits super nice. Not sure I’ll ever need any of the others but I have them now Incase [emoji6]

Sent from my iPhone using Tapatalk