My Nylint

[HVFracingwilly]

well here it is i stretched it to about 9 1/2 inches with a custom 4 link sutup
buggy has:

1. custom 4 link setup
2. oil filled coilover shocks
3. stretched wheel base
4. widened 1/2 inch
5. cut tires

this weekend it will get full custom electronics including a novak speedo hitech servo and an airtronics m11 radio also on the list is 2.2s and more travel...;-)

 

[Darth Balls]

Are you not running springs on it, and if not does it make it sit pretty low?

 

[HVFracingwilly]

i ran it without springs for a little while(shocks were in the stock position) then i moved them to where they are now and had to put team losi whits springs on it(cut about 4 coils of the spring and it sits perfect.
if you guys have antmore questions just shoot them at me.

 

[Darth Balls]

What did you do to widen it a half inch, I was able to squeeze about a quarter out of mine.

 

[HVFracingwilly]

i used team assosiated down stop spacers they measure .25 inches and i installed them behind each wheel.

 

[cutlaSS]

Cool buggy. Do you think you could show some pics of where the links mount to the chassis and axles? I was also thinking of widening my truck with spacers behind the wheels but I'm alittle worried about the hex engagment. Do you think the hubs or axles hex will round off? I'm especially worried cause I run 2.2s

 

[HVFracingwilly]

i would think with 2.2 you prob. gained enough width and i would recomend not doing it it only has about a 1/8 of an inch grabing the wheel gunna try to get some 2.2 pretty soon ill let you know how that goes