My XR10 - Carbon and Ti ..

[eXtremeCostumez]

Got started ..

Finished the kit..

But the end of the kit , is just the start of modifying :twisted:

Parts used:
-Bronze Bearings
-handmade carbon chassis with longer arms in the rear
-handmade titanium links ..
-handmade ti stearing rod

electrics will be:
-Futaba 4Pl
-2x Castle Microsidewinder
-2x Team Brood 45T
-Hitec Hs7950TH
-Castle BEC

The wheels will be custom wheels from a friend ..
Tomorrow I will make some new carbon parts for my XR10 .. Upper links are finished yet , just had to mount them (also titanium "thumbsup")
I also will add some VP parts , C-Hubs , Knuckles and so on ..

So far ..

 

[Harvo]

Nice photographs!

 

[eXtremeCostumez]

..after selling my V2 Berg I decided to buy some new parts for the XR10 ..

-Holmes Hobbies 35T Team Edition
-Vanquish C-Hubs black
-Vanquish Knuckles black
-Vanquish trans cases black
-Vanquish motor plates black
-Vanquish front link mount black
-Vanquish rear link mount black
-Vanquish lockouts black

Than I started with the front axle:

..the rear:

Finally mounted the motors:

Actually I´m waiting for my new chassis and two esc ..

 

[KBrog]

Great carbon fiber frame. You will like the extra upper link mount holes. I drilled out my stock aluminum XR frame in a similar pattern for more adjustability.

 

[eXtremeCostumez]

Finaly I got my new chassis and ESC this week , so Friday night was very short .. but I finished it around 4 hours before the comp on saturday , so I was able to drive it.

I needed course 1 - 3 to get used to the new car ,but in course 4 I was able to finish without any mistake and a score of -20 on 10 gates "thumbsup" so I could finaly finish on the 3rd place.

By the way , chassis is a CDW , ESC are two GM Sx6r.