RC4WD AD Atlas II T-case

[distinctive pd]

Anyone have one yet? I ask because there is no info on internals as far as how many gears are used internally. The reduction is the same as the hammer but for certain reasons I'm curious if this is achieved with 2 gears or 3 like the hammer. ...

I'm hoping 2 gears but if anyone knows please speak up?
thanx!

https://store.rc4wd.com/RC4WD-Advance-Adapters-Atlas-II-Transfer-Case-1471_p_5835.html

 

[CM9000]

it looks to only be 2 but I could be wrong. might have a small "pinion" in between.

 

[calcagno45]

It says 8 bearing design. 2 bearings per shaft, does it have 2 idler gears?

 

[DrewHammer]

My guess is 4 bearings per shaft, 2 per side. 2 total gears that are, as a result of bearing width, really narrow.

Hope I'm wrong though, it seems neat.

 

[calcagno45]

My guess is 4 bearings per shaft, 2 per side. 2 total gears that are, as a result of bearing width, really narrow.

Hope I'm wrong though, it seems neat.

It also says wide gear design so not sure that’s the case.

 

[distinctive pd]

Thanx doods RC4WD got back to me and it is basically the same as the hammer with 3 gears. Was hoping for a two gear T case. Will just have to build 1 "thumbsup"