Sanwa m12 moa dig

[me88894]

Gday I recently picked up a sanwa m12 and finally can run proper dig and burn on my Xr10. I've been messing about with it and I've got it working kinda. How do I setup variable overdrive and dig at the same time? If I set the lever (or a trim switch) to the moa mixing I can do dig and burn with the selected control but I can't figure out how to make the variable overdrive work the manual mentions it can be done but not how. Any pointers?

Sent from my Pixel 4 XL using Tapatalk

 

[Ftek23]

Hello, you have found a solution for this problem, I am in the same situation, I just received this remote and I am blocked ...

 

[WHITE-TRASH]

Depends on the m12 from what I understand. The m12rs doesn't have the same dig setup as the earlier m12 or m12s. I have an mt4 and the mixing is on the lever and variable drive bias is on the dial. I don't use the dial though, my thumb never leaves the lever, I'm always adjusting the mix, it's not something you just set and leave on a MOA.

 

[Ftek23]

thank you for the answer, i have the m12 RS and so for you i can't do the dig mixing like the mt4....? (i don't really understand what i cannot do and some word (explanation in english are difficult for me sorry...)
So for an moa it's not good...?

After reading again the manual i understand....i can't assign the dig on lever only the MOA Mix !!!!
So White Trash you were right........

Great,this radio it's not good for MOA.............:evil:

 

[WHITE-TRASH]

thank you for the answer, i have the m12 RS and so for you i can't do the dig mixing like the mt4....? (i don't really understand what i cannot do and some word (explanation in english are difficult for me sorry...)
So for an moa it's not good...?

After reading again the manual i understand....i can't assign the dig on lever only the MOA Mix !!!!
So White Trash you were right........

Great,this radio it's not good for MOA.............:evil:

Sometimes translation loses information but I think we can work though it well enough. :ror:

On an earlier model airtronics with a lever you can use the lever to change the mix front and rear and the dial does the same thing but it is easier to leave it at +20 front etc so when the lever is at 0 mix the front still has overdrive.

 

[Ftek23]

;-)"thumbsup"
Ok i understand thank you

I solve the problem....i keep the m12 for my other rig and i bought an mt4 for the MOA:mrgreen:"thumbsup"

 

[WHITE-TRASH]

That's the easy solution, I'm very happy with my mt4.

 

[CM9000]

System-assign-lever- moa mix scrolling all the way up. It works on the m12s rs.

Only problem is, mine doesn’t stay assigned. So every time I switch models or turn off radio, it losses the assigned function.

If yours doesn’t work at all, you need the updated firmware.


Sent from my iPhone using Tapatalk