Sidewinder micro 2 and flysky gt3b problems getting it to work

[rcbasher12]

I have an XR10, 2 castle creations sidewinder micro 2 speed controls and a hacked flysky gt3b. I have found on YouTube a video on how to set up the radio for dig and the adjustment of power to front or rear axle which I did everything they sad to do, but when I activate the dig in either direction, the axle that is supposed to stay stationary spins slowly forward. No matter what I do I can't get it to work any help would be very much appreciated thanks

Sent from my iPhone using Tapatalk

 

[StomperCrawler]

Prolly need 2 adjust the trim on that channel.

 

[rcbasher12]

Not a noob to R/C or crawling for that matter but kinda noob on the MOA scene. Thanks for your help I was able to get it to work by broadening the neutral zone on both the speed control and the radio and adjusting the trim and sub trim.


Sent from my iPhone using Tapatalk

 

[StomperCrawler]

Wtg. Good job figuring it out!

 

[losikid]

Your radio wasn't calibrated correctly. I suggest recalibrating your radio

http://www.rccrawler.com/forum/elec...ck-question-answer-thread-15.html#post3213031

Then setting your other settings back to default so you're not "band-aiding" the problem since the wrong calibration offset causes many different issues.

And make sure to recalibrate the esc's after you recal the radio