Single speed Gear Ratio

[dpcardoza]

I can’t seem to find any information on the gear ratio that the single speed conversion creates. I’m currently running a 1900 slate motor and just bought some 4cell lipo’s so was thinking about ditching the 2 speed


Sent from my iPhone using Tapatalk

 

[wrightcs77]

I can’t seem to find any information on the gear ratio that the single speed conversion creates. I’m currently running a 1900 slate motor and just bought some 4cell lipo’s so was thinking about ditching the 2 speed


Sent from my iPhone using Tapatalk

Same as first gear.

Sent from my Pixel XL using Tapatalk

 

[dpcardoza]

Same as first gear.

Sent from my Pixel XL using Tapatalk

1st gear is pretty low. Do you feel like it mind “wind up” creating too much heat. I figured moving to 4’s and gearing down a bit would give me a decent wheel speed without sacrificing crawlability.


Sent from my iPad using Tapatalk

 

[wrightcs77]

1st gear is pretty low. Do you feel like it mind “wind up” creating too much heat. I figured moving to 4’s and gearing down a bit would give me a decent wheel speed without sacrificing crawlability.


Sent from my iPad using Tapatalk

I think 4s on the 1900 would be great. Just no long full throttle runs.

Sent from my Pixel XL using Tapatalk

 

[Orange peel]

1st gear is 2.00:1 so probably looking at 6.5-7mph wfo fully charged

 

[wrightcs77]

1st gear is 2.00:1 so probably looking at 6.5-7mph wfo fully charged

Final ratio in first is 65:1

Sent from my Pixel XL using Tapatalk

 

[tuanies]

Haven't had any problems running 4S with the 1900kv Slate motor yet. Runs fine in low gear.

 

[Orange peel]

First gear is 2.00:1 First gear final is closer to 64.595

 

[Inspector86]

I hadn't seen that mod released.