Snow track fitting problem, help needed!

[Teamsherman]

Hi guys,

I'm just after some as I have recently got back into the crawler scene by way of Tamiya CC01 Landcruiser (original FJ40 series shell) and am looking at turning it into a bit of a mud and snow basher.

I bought some snow tracks but only realised once they got here (Australia from America) that they dont fit straight on and need some sort of adapter. I did try to contact the seller to ask before I bought them but didnt ever get a response so I thought you guru's here should be able to help me out!

I have posted a few pictures of them below in the hope that someone else has successfully fitted them and if so can you please tell me what adapter I need and the best place to get it? The chassis is unmodified and the currrent wheel adapters are all stock.

Your help would be greatly appreciated! And once they are on I will post some pics and video of the little beast in action!

Cheers,

Alan.

 

[Teamsherman]

Ok, so I got them to fit and function by just removing the R-shaped support on the inside but I think due to different ratio's they wont be any good unless I have the same set for the front so I'm going to have to wait a little longer before I can actually use them.

Still would like to know if there is an adapter kit for them as I would prefer to fit them whole and without the adapter kit they tend to turn too far catching on the body shell.

 

[crashlot2]

contact RC4WD and ask them