I just purchased a Wraith a week ago and it's been a lot of fun. After my first run with it, it was painfully obvious the supplied steering servo was not going to cut the muster.
I went to the hobby shop where I bought the unit to discuss this.
I mentioned I wanted something will over 300 oz/in and they sold me a Spektrum A6270 which is well over 300 oz/in at a rated 582 oz/in at 8.4 V.
I'm not going to pretend, I have no idea what I bought. I went in looking for a bigger number, came home with a bigger number.
I asked "this'll plug in and work, nothing else needed?"
They sold me a Losi LOSA99037 servo arm (23 spline count to fit the servo) and said it'll plug right in and work great.
Took everything apart, hooked it up, screwing everything back together, and I don't have anything that screws into the threaded holes on the LOSI servo arm.
I've done some googling and I can't seem to get any answers as to the thread it is.
For now, I found a 23 spline servo arm in the parts pack that came with the unit and it 'works' but it doesn't seem to sit over much of the splines, seems like it'd strip out pretty easy.
Anywho - looking for information:
1: Thread size for the Losi Servo Arm (or should I get a different arm)
2: Is this servo going to work with the AX-3 radio w/o issue?
Thanks and sorry for being a n00b, we're all there at some point, now is my time!
I went to the hobby shop where I bought the unit to discuss this.
I mentioned I wanted something will over 300 oz/in and they sold me a Spektrum A6270 which is well over 300 oz/in at a rated 582 oz/in at 8.4 V.
I'm not going to pretend, I have no idea what I bought. I went in looking for a bigger number, came home with a bigger number.
I asked "this'll plug in and work, nothing else needed?"
They sold me a Losi LOSA99037 servo arm (23 spline count to fit the servo) and said it'll plug right in and work great.
Took everything apart, hooked it up, screwing everything back together, and I don't have anything that screws into the threaded holes on the LOSI servo arm.
I've done some googling and I can't seem to get any answers as to the thread it is.
For now, I found a 23 spline servo arm in the parts pack that came with the unit and it 'works' but it doesn't seem to sit over much of the splines, seems like it'd strip out pretty easy.
Anywho - looking for information:
1: Thread size for the Losi Servo Arm (or should I get a different arm)
2: Is this servo going to work with the AX-3 radio w/o issue?
Thanks and sorry for being a n00b, we're all there at some point, now is my time!
