SXC10iii Gladiator rear driveshaft length and part number

[halllon]

Does anyone know the pin to pin length (and how long you can safely expand it to) for the SCX10iii Gladiator super long WB8 driveshaft (the 13.9" wheelbase model)?

And is that long driveshaft available for purchase anywhere?

 

[halllon]

Will this kit have the tubes to build that long shaft?

https://www.amainhobbies.com/axial-wb8hd-driveshaft-set-2-axi31133/p363523

 

[lonleycreeper]

Will this kit have the tubes to build that long shaft?

https://www.amainhobbies.com/axial-wb8hd-driveshaft-set-2-axi31133/p363523

I dont think so, The original kit had only driveshafts long enough for 12.5" or so

 

[halllon]

I dont think so, The original kit had only driveshafts long enough for 12.5" or so

Copy that, thank you. A lot of Axial spare parts seem to be difficult to get :/

 

[UZI4U]

I know this thread is old, but I was looking this up this week and thought I’d put the info here that I got from Horizon Hobby Support.

SCX10 III Jeep JT Gladiator uses driveshafts that are approximately 91mm (collapsed) to 125mm (extended)