TXT with clod axles?

[nUbie]

Hi folks, i´m lookin for close up pix of TXT´s with clod axles. Where do you mount the txt push rods to the clod gear case? I´m still wondering how to arrange all the servo/steering mount, these metall stiffener parts and the push rods. Upper and lower link is no question.
Oh btw i want to keep the cantilever system so please give me some advise.

greetings from good ol´ Germany "thumbsup"

 

[nUbie]

I wasnt sure if I had better asked this question on the clod board... anyway.

OK just to complete this topic.:


This is how I mount the clody`s to my TXT chassis. Note I want to keep the Monster Truck look (no super or competition) just with the ability to crawl some rocks. Still have to figure out the servo mount. I will add a Chevy body (not sure which one yet) another Hitec on the rear axle and the clod sized Mudslingerz.
BTW locked diffs 8 and 9 T pinions + 55t Integy´s

Thanx guys
take care
Sven

 

[nUbie]

Finaly got the rig done. Just wanted to show you what I came up with. And btw in my opinion its still a TXT, I just swaped the axles, hope all you shaftie guy´s dont´t take it amiss to post the Chevy on this board. :twisted: LMKWYT

 

[Mark-013]

It's an unexpected combination, but it looks good!

 

[flatfender]

I would consider it a clod with a TXT chassis, but thats just me.

 

[RcFrankenstein]

i'ld have to say its a clod with txt chassis also

 

[SUPERINVA]

Definately a CLOD !!! But I'm biased. I have owned Clods since 95.

 

[AXLE 69]

Dude, bottom line is you can't go wrong with a CHEVY! Awsome truck man!