Vanquish slw hub size

[XJkid93]

Hey guys i am going to order some slw rims and hubs so i was wondering if anyone has some slw rims that could tell me the proper hub size that would be good for an xr10 i want to keep the rear skinnier than the front like it come stock. i was told that the 600 hubs would be a good choice but seems a bit wide so if i could get some measurements or if the 600 hubs would be good. i also plan on running knuckle weights for it and want to be able to throw at least 2 extra rings on if needed. thanks again for all your help!!!:mrgreen:

 

[ittybitty]

I would suggest 350's up front and 475's out back. This will keep the rear slightly narrower than the front. If you wanted to even them up then bump the rear hubs up to 600's.

VP lists what is required to fit a certain number of rings on the XR10 on the page for the weights here: http://www.vanquishproducts.com/xr10-brass-knuckle-weig10.html

 

[benoj]

On mine I run either 225 up front and 350 in back or 350 front and 475 back


Sent from my iPad using Tapatalk

 

[ax10tn]

i am running 475's up front and 600's on the rear with slw's and is the perfect width for sidehilling etc i was running 350's but it was a little sloppy on sidehills then i went to 475/600 and works awesome..."thumbsup"

 

[XJkid93]

Does anybody have the width measurements with different size hubs for the slw rims? I can't find them anywhere and have been sear hint for two days now. I'd like the front and rear axle sizes. Like what the width with a 1" rim would be with different size hubs. Thanks

 

[ax10tn]

i am running shaved Boss Claws with 1' slw's 475's out front and 600's on the rear front width of the outside of the tire to outside of the tire is 11' front and 10 9/16