| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
03-08-2018, 02:52 PM
| #1 |
| Rock Stacker Join Date: Jan 2015 Location: where the sun shines
Posts: 54
|  Ecx barrage cuting out? Esc?
My sons ecx barrage has been a great rig. I let him run a 2s and its been fine for about 2 months. Now after driving for 5 mins it will cut out and only steer. Once turning off the ecs and then back on we can get another 5 mins out of it. Is this do to the esc being over powerd by the 2s and some kind fail safe comes on?
|
|  |
| Sponsored Links | |
| | |
|
03-08-2018, 04:48 PM
| #2 |
| RCC Addict Join Date: Jan 2012 Location: Vancouver
Posts: 1,921
| Re: Ecx barrage cuting out? Esc?
After it cuts out is the motor to hot to touch?
|
|
| |
|
03-09-2018, 08:47 AM
| #3 |
| Rock Stacker Join Date: Jan 2015 Location: where the sun shines
Posts: 54
| Re: Ecx barrage cuting out? Esc?
I have not checked that. But i will today. We did have a bit of long grass spool up on the in the inside of the front wheels then the problem accrued after we cleaned them out. Are u recommending a burnt out motor? Id much rather replace that then a esc lol
|
|
| |
|
03-09-2018, 09:31 AM
| #4 |
| RCC Addict Join Date: Jan 2012 Location: Vancouver
Posts: 1,921
| Re: Ecx barrage cuting out? Esc?
Its a know problem at least in the rtr version 1 barrages. Its geared to high from the factory. I made an upgrade bible for the barrage the thread is in the general scale section. Lots of info and still adding stuff to it.
|
|
| |
|
Ecx barrage cuting out? Esc? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ECX 1/24 Barrage | casper975 | Chit Chat | 8 | 12-10-2017 11:39 AM |
| |
Linear Mode
