Wraith axles splines vs scx10 axle splines
 

Hi this is my first ever thread and i have a question
Would scx10 chubs fit on ar60 axles i only own ar60's and I need to know this information for my build.
Any information is helpful and pictures would be very much appreciated.

Re: Wraith axles splines vs scx10 axle splines
 

Its not a bolt on (Ar60s are splined, Ax10 are keyed) but they can be made to work.

Re: Wraith axles splines vs scx10 axle splines
 

What modifications would have to be done in order to do this

Re: Wraith axles splines vs scx10 axle splines
 

Now that im looking back i meant scx10 ii axles instead of scx10 axles.

Re: Wraith axles splines vs scx10 axle splines
 

The splines are a little different, but my Vanquish AR60 c hubs will slide onto SCX10-II housings, so it can probably work the other way too with a little modification (SCX10-ii axles need a groove in the axle housing to clear/support the c hub clamping screw). The big problem you'll run into is axle shafts. AR60 shafts will not work in a SCX10-II knuckle. The distance between the inner bearing seat and the center of the joint is too long.

Re: Wraith axles splines vs scx10 axle splines
 

Thanks that is actually very helpful. i was going to need the change the drive shafts anyways to do what I wanted to do. Could you post a picture of what you mean about the clamping screw.

Re: Wraith axles splines vs scx10 axle splines
 

The hole in the bottom of the c-hub clamps the c-hub to the axle housing. The axle housing has a groove around it where the c-hub mounts to clear this screw which also keeps the c-hub from sliding off once installed.
http://www.axialracing.com/assets/pr...JPG?1463697008
http://www.axialracing.com/assets/pr...JPG?1463702655