|
| LinkBack | Thread Tools | Display Modes |
01-16-2012, 07:40 AM | #1 |
Quarry Creeper Join Date: Sep 2010 Location: Perth Australia
Posts: 322
| FastBack II MIP Shaft???
Hi guys im in the process of building up a fastback II chassis based sportman rig and im chasing a bit of info/help in regards too driveshafts? I want too run MIP driveshafts on it, and was wondering what ones to purchase? Cheers in advance Clint.. |
Sponsored Links | |
01-16-2012, 08:56 AM | #2 |
Rock Crawler Join Date: Aug 2010 Location: Socal
Posts: 699
| Re: FastBack II MIP Shaft???
With the 60/40 design of the Fastback I had to run the MIP dig style shaft in the front and the regular in the rear. This is with the spur gear in front.
|
01-16-2012, 09:11 AM | #3 |
Quarry Creeper Join Date: Nov 2011 Location: Cookeville
Posts: 412
| Re: FastBack II MIP Shaft???
If you check out my build thread you can see the dig one up front and the reg one in the rear and i think i even answered a question about how much shaft i had left in the rear and you can also just cut down the reg for the front also with a drimel if you have the good cutting blade and vise. There are alot of good FB II builds on this forums use them to your advantage.
|
01-16-2012, 10:08 AM | #4 |
Rock Crawler Join Date: Aug 2010 Location: Socal
Posts: 699
| Re: FastBack II MIP Shaft???
This is one of the best. I studied this thread a lot when building my Fastback. Not a FB II but the same basic setup applies. Only difference in the chassis is the front shock mount. Underground Crawlers Fastback chassis |
01-17-2012, 07:35 AM | #6 |
Rock Crawler Join Date: Aug 2010 Location: Socal
Posts: 699
| Re: FastBack II MIP Shaft??? |
FastBack II MIP Shaft??? - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MIP shaft angles ? | pook | General Scale Talk | 1 | 06-12-2011 07:40 PM |
| |