(New questions) 2-14 Need some help with my new gatekeeper OK so I got a gatekeeper chassis and I was putting it together today but when I went to put on the side plate next to the motor, the side plate sits against the spindle on the motor. Right now I have the stock 14t pinion on there. Would going to a smaller pinion allow the motor to move in just enough to clear the side plate? Or is there something else I can do? Here a picture. Sorry about the best I could do. http://img.tapatalk.com/c6e4e2a8-accc-6fb2.jpg Sent from my i777 using Tapatalk. |
Re: Need some help with my new gatekeeper Do you have the tranny mirrored? |
I don't think it is mirrored. I think its in the stock orientation Sent from my i777 using Tapatalk. |
Re: Need some help with my new gatekeeper Try mirroring it |
Noob question but what good will mirroring the tranny do when its hitting the motor Sent from my i777 using Tapatalk. |
Re: Need some help with my new gatekeeper I had a similar issue on my wedge. I ended up cutting the motor shaft. I can't tell from the picture if it's rubbing the pinion also if it is, cutting the shaft will not help. |
Re: Need some help with my new gatekeeper did you flip the skid so the spur gear is in front? if not, i'd do that! |
Its just hitting the shaft. Its close to the pinion but not touching it. And I think its to the front. Its however the instructions say to do it. I'm at work now. Ill have to look when I get home. Edit. Its to the back because my rear drivrshaft is twisted Sent from my i777 using Tapatalk. |
Re: Need some help with my new gatekeeper Quote:
|
Re: Need some help with my new gatekeeper It was like this on the GC3A i bought for my friend. I just the shaft down a few mm. You won't trim off nearly enough to affect the way the pinion seats. |
Re: Need some help with my new gatekeeper mirroring it made everything worse theside plate now hits the motor case and doesnt even come close to lining up |
Re: Need some help with my new gatekeeper Did you flip the skid? |
What do you mean by flip the skid Sent from my i777 using Tapatalk. |
Re: Need some help with my new gatekeeper the spur gear should be in the front, dont mirror the trans. |
Flip the skid upside down? But then the holes aren't counter sunk Sent from my i777 using Tapatalk. |
Re: Need some help with my new gatekeeper Quote:
|
Re: Need some help with my new gatekeeper ive seen a few post here about some gc3a skids being drilled a little off. maybe you have one of these skids. if so i would either drill new holes on the other side or cut some of the motor shaft off. |
OK so I got my gatekeeper together and almost done hooking everything up. Now I noticed I have a twisted drive shaft and I was wondering if anyone had a couple different recommendations. Also. Can anyone recommend a cheap lipo 2s and a charger? Sent from my i777 using Tapatalk. |
Re: (New questions) 2-7 Need some help with my new gatekeeper MIP's, Any 2s lipo, venom or traxxas lipo charger. |
Are those shafts bolt in replacements Sent from my i777 using Tapatalk. |
All times are GMT -6. The time now is 01:46 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com