driveshaft issue Hey guys, I set out to build a crawler and ended up with a sporty AX10 thing. SCX axles, SCX trans with HR dig unit. It has 4WS and I doubt it will ever see a real competition. Its built for fun. The issue I have is with the rear shaft. The HR dig unit really limits the diameter of the shaft I can use at the trans. I had a stock axial shaft in there and after a few bounces its destroyed. What is a good solid strong shaft that will fit here? I have a set of worn junfac shafts but I don't like them as they don't like to slide very well when under load and this DIG needs the shaft to slide easily. Any help would be appreciated Joe |
Re: driveshaft issue Well never mind on the driveshaft issue. I just seen that VP has their hurts shifters on sale for $69.99 shipped so I have one ordered. No black in stock so I went silver |
Re: driveshaft issue Anyway for strong drive shaft, MIP is unbeatable but they are heavy. Junfac is actually quite good except a bit of slop. Other than that, Maxx shaft is light and strong. |
Re: driveshaft issue I have MIPS and junfacs and traxxas stuff but on the HR dig unit there isn't much room at all for anything much larger then a stock axial shaft. I don't really like the HR dig so I ordered the VP hurtz dig. I can run any shaft on that and it's a better unit from what I see. |
All times are GMT -6. The time now is 07:07 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com