Electronics Mounting

[kkipp9]

I am getting farther in my Bomber build. I just installed the receiver box today and I ended up with some questions concerning mounting locations of the electronic bits.

First is the antenna wire from the receiver. What is everyone else doing with theirs? Can I just wind it around inside the receiver box without losing signal? I know that with these types of vehicles you are never really very far away.

Another question, where are people putting the BEC? I can fit it inside the receiver box but it sort of shortens the battery lead being soldered together. Would it be a heat issue with this being inside of the box?

Last question, the ESC location. I have a Castle Creations MMP. It is pretty big. Will it fit on top of the receiver box and still allow for the installation of the interior?

Thank you for the help.

Sent from my SM-G930V using Tapatalk

[Rjohn929]

I keep my antenna and BEC in the stock box (just extend the wires if need be) and my Holmes BLE in the stock location. No problem. Pretty sure your MMP will have no problem there either.


Sent from my iPhone using Tapatalk

[shiftauto]

I have the mamba max in the stock location. It's tight but fits in there with the interior.

[byrnieman]

Same as above but I had to take the little bracket off that runs across the bottom of the windscreen - it ended up fouling on the ESC & didn't let the cage go down far enough for mounting.


Sent from my iPhone using Tapatalk