Wrangler Scaler Idea and Question

[hozer]

I plan to use the scx10 skid/transmission mount on GCM Crosscanyon frame rails, mounting it in the conventional center body location. I know guys have to cut the center console for the spur gear when using the axial frame rails. If I lower the cross canyon rails so they are near or slightly below the edge of the side steps/ body, will the complete motor, trans, and spur fit without cutting the console?

Since I'm mounting it on new rails, I can locate the transmission forward or backward as much as I need to. Obviously I may have to get new driveshafts. I want the body as tight to the frame as possible because this is going to mimic a 2.5" lift on the 1:1. I'll be using 1.9's and 100mm +- tires.

Thoughts?

[hozer]

Why don't I just try it? Forgot to mention, I haven't bought an SCX yet.

[hozer]

Found the wheels I want. BWD vertex 1.9. Anyone have some to sell?

http://a1.l3-images.myspacecdn.com/i...db5341c7/l.jpg

[hozer]

I still don't have the trans and motor in hand but I went to tne store and measured. My idea won't work. At 3" top to bottom, the skid will be too far below body. If I lift the body, the 1:1 lift will look like 6". Just like all the other scx10 / new brights.

I may go custom rails. Similar to crosscanyon combo, but better fit for low lift.