Steering help When I turn right I can go till the knuckle hits the c-hub and beyond. But when I turn left the servo stops before it hits the c-hub. Tried adjusting the end points, so going right it stops where it should. But still can't get everything out of it, going left. Not sure what to do at this point. I'm running a savox SW-0231mg servo. Any input helps. http://i982.photobucket.com/albums/a...ps3z5k4lvv.jpg http://i982.photobucket.com/albums/a...psujw5ok6l.jpg |
When the truck is powered off can you manually move the servo horn to full lock on both sides? |
Re: Steering help often the servo is not centered properly on it's mount. try loosening the servo screws... and attempt to shift the servo L or R... in the direction that will be most neutral (centered) to your endpoint adjustment capability. re-tighten and test again. * remember to adjust your TX's servo trim to center before adjusting the servo. |
Re: Steering help also you can unscrew and remove the servo horn before you centre the servo then straighten your wheels and re-attach the horn! |
Re: Steering help Thx guys I'll try those things once I get home. |
Re: Steering help All fixed. Took the horn off, turned on the truck, let the servo center itself. Then reattached the horn. Full steering in both directions :ror: |
All times are GMT -6. The time now is 06:32 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com