question on scx10 front axle Hi guys. I put the hot racing aluminum knuckle and C hub on my scx10 and now after a couple trail runs the screw comes lose from the C hub. Sometimes the screw will almost come out. Any suggestions? |
Re: question on scx10 front axle Maybe you stripped the thread into the axle...you may try with some glue...Or add the beef tubes! |
Re: question on scx10 front axle I don't think they stripped out. I did lock tite them. What is a beef tube? |
Re: question on scx10 front axle |
Re: question on scx10 front axle loctite should hold them in... did you replace the stock screws with machine screws? |
Re: question on scx10 front axle Quote:
Must do! |
Re: question on scx10 front axle I replaced the screw that came with the C hub. They where not a fine thread if that is what you mean. |
Re: question on scx10 front axle Quote:
|
Re: question on scx10 front axle How hard do you guys think it would be to make one out if a scrap tube? |
Re: question on scx10 front axle Quote:
If you know the required specifications, have some experience with tooling and already have the necessary tools/materials. ^ If you're not confident in your ability or lack the proper tools... then IMO yer better off buying them already made. Accuracy will be critical to insure that the grub screw's drilled/threaded holes line up properly. I own all the proper tools... and still chose to buy rather then fabricate my own. |
Re: question on scx10 front axle I got tools to make stuff like this. So I mite have a go at it thanks guys for the help. |
All times are GMT -6. The time now is 11:32 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com