Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) I can see some jittering in the first vid. Since you swapped out both ESC and motor for the second vid, we can't determine whether motor or ESC is the root. Since the BLE firmware is based on the MMP, it would lead me to believe the Puller sensor board may have a sensor that isn't triggering proper. I know you have an email in with customer support right now in regards to the throttle jitters. Let them know about the servo and we will see what can be done for you. |
Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) Would you suggest I try the MMP with the Puller Pro motor and the BLE Pro esc with the Pro4 motor (I've only run the Puller Pro motor with two BLE esc's and the pro 4 with the MMP esc), or just proceed with Customer Support on swapping the Puller and Servo? I'm definitely learning towards the motor being the cause, I've tried two BLE Pro esc's, both brand new, both netted identical stuttering. Quote:
|
Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) I'm running pretty much that exact same set up only difference is I don't have a stubby... I'm using a venom 5000 mah 11.1v 3s 20c and it runs smooth like butter Sent from my SAMSUNG-SM-G891A using Tapatalk |
Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) Quote:
Quote:
Sent from my SAMSUNG-SM-G891A using Tapatalk |
Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) Quote:
Sent from my SM-N920V using Tapatalk |
Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) I got it geared 56/9t wheels speed is walking speed @ best. hill climbs no ,crawling YES! Sent from my SAMSUNG-SM-G891A using Tapatalk |
Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) i had a similar problem with my stubby motor. when i installed the electronics i forgot to calibrate my esc. ounce i did that everything worked fine. im running mmp esc. |
Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) I've calibrated my Esc, two esc's in fact. Thanks for the input, every idea helps! Quote:
|
Re: Scx10 II = Wow! (Plus SSD DIY hex bolt tool) No problem, good luck! |
All times are GMT -6. The time now is 02:15 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com