|
| LinkBack | Thread Tools | Display Modes |
11-01-2011, 03:23 AM | #1 |
Rock Crawler Join Date: Sep 2011 Location: FNQ Australia
Posts: 681
| rear axle bind on kit build
I've searched and cant find an answer to my prob. About 1/2 way thru my kit build and had an issue with the short axle on the rear . The splined fixed end that slides onto the housing would not engage fully leaving about 1-2mm of spline visible. When I forced the gap together by putting in the screws that attach it , the bearings would bind , only just being able to turn the axle. After pulling the thing together 3 times I drilled the holes in the end tubes oval so there was no bind , with the spline visible . Its an ugly fix but I could not work out what was wrong . Anyone else struck this or have any clues what could be wrong ? Its only the short side and the same if I spin the diff the other way . I'm stumped , thanks for any suggestions. |
Sponsored Links | |
11-01-2011, 04:53 AM | #2 |
Quarry Creeper Join Date: Apr 2008 Location: PNW
Posts: 412
|
Common problem Rear axle short shaft issue? |
11-01-2011, 07:16 AM | #3 |
Rock Crawler Join Date: Sep 2011 Location: FNQ Australia
Posts: 681
|
cheers 322 , some quick fixes there too .
|
| |