xr10 and fxr setting

[bikeboy]

can someone share what you have for your setting on the fxr on the xr10?
I have a 3s 11.1v lipo and a 4pk
i also have the tekin hotwire and this is my current setting
first build so no idea what a good starting point for the setting

[Pdog7]

1 or 2 fxr'2?
If 2 front drag brake about 60% rear 95%.
Reverse type f/r
Voltage cutoff 3
all else you have is fine

[bikeboy]

2 fxr
so for both fxr i set the Reverse type f/r?
I swear its impossible to find an area where people post something like this for a baseline.
Thanks

anyone else?

[bikeboy]

So I went in and use what Pdog7 suggested
here's the front setting for the xr10 - (2fxr - 3s lipo and 35T motor)

Front setting




__________________________________________________ ______________________
Rear setting




going to give this a run tomorrow and see how it goes

[Scottmisfits]

I'd turn down the neutral width. I have mine set at 15-20. What that is is the amount of throw in the trigger before the signal is sent, put very simply. So at 67 on the neutral width, you have to move the trigger pretty far.

[smanders]

Hello,

It looks like these images are not working anymore. Could someone post their Hotwire FX-R settings? I'm in the midst of setting mine up and want to make sure I'm not missing anything.

Thanks,
smanders

[Highlucks]

Try searching the electrics section. I think there is also a thread in there.

[patrol king]

anyone

[ManxCrawler]

I run -100% throttle expo on mine, it means I can move the throttle a fair way through the slower sections of a course, sometimes you just want your rig to creep through part of a gate and 0% throttle expo makes it really jumpy