| |
11-19-2015, 08:44 PM
| #1 |
| Rock Stacker Join Date: Nov 2015 Location: Lubbock
Posts: 95
|  Keep dropping a pin
So page 19 step 18 assembling the front drive shaft. What is supposed to be capturing the pin that holds the drive shaft to the coupler because it keeps falling out and I'm getting frustrated? It's part# AX31028  Last edited by amped up; 11-19-2015 at 08:50 PM. |
|  |
| Sponsored Links | |
| | |
|
11-19-2015, 08:55 PM
| #2 |
| Quarry Creeper  Join Date: Jun 2013 Location: Canada
Posts: 403
| Re: Keep dropping a pin
the plastic sleeve AX31114-1 captures the pin and the whole thing is held in place once it is attached to the front diff
|
|
| |
|
11-19-2015, 09:07 PM
| #3 |
| Rock Stacker Join Date: Nov 2015 Location: Lubbock
Posts: 95
|
But ax1148 has a hole that runs through it so the pin can slide in as the instructions show but then will drop out the bottom side. I think I see what your saying but it doesn't appear 31148 is sliding into 31114 to capture the pin Such an idiot, I didn't even have 31114 installed Last edited by THX_138; 11-20-2015 at 10:45 PM. |
|
| |
 |
Keep dropping a pin - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dropping by to say hello! | DieselMunkey | Chit Chat | 4 | 12-26-2011 10:04 AM |
| just dropping by to say... | hollywoodheidi | Comments, Suggestions, and Help | 0 | 10-19-2007 01:48 AM |
| |
Linear Mode
