| |
08-02-2008, 03:08 PM
| #1 |
| I wanna be Dave  Join Date: Jan 2006 Location: Iowa, the antirecreation state!
Posts: 2,227
|  Novak EVX failure.
Too many roll overs I'm guessing.   This chip, if that's what it is, came loose inside my ESC. It is labeled 4.00M. Any one no how to reattach it? There are no protruding pins through the board. There are three, what look like, solder joints in the center of the underside of the "chip". Maybe I can get just the complete board that pins onto the lower level? I am probably out of luck, but this is my only ESC right now. Yah yah buy a better one. If I can fix this one to buy me some time, that's more better. |
|  |
| Sponsored Links | |
| | |
|
08-04-2008, 02:13 AM
| #2 |
| Rock Crawler Join Date: Dec 2007 Location: GILBERT
Posts: 751
|
is there anywhere under the heatsink that it can go?
|
|
| |
|
08-04-2008, 03:36 PM
| #3 |
| I wanna be Dave Join Date: Jan 2006 Location: Iowa, the antirecreation state!
Posts: 2,227
|
I no where it goes. Just to the left of the large chip in the center of the board. I just don't know how to reattach it. There are no soldering joints/pins.
|
|
| |
 |
| |
Linear Mode
