|
| LinkBack | Thread Tools | Display Modes |
10-31-2010, 03:29 PM | #1 |
Quarry Creeper Join Date: Oct 2010 Location: Clovis, NM
Posts: 341
| Wiring two FXR's and a BEC to a SR300 RX help!
I am running a DX3E TX. I want to wire 2 FXR's, a BEC, and a servo. My question is should i wire the BEC from the battery to the reciever, or from the battery to the servo? Also, where would i plug the ESC's, BEC (if i choose to wire it to the reciever), and servo into my reciever?, which has the following plug ins: 1) AUX 2) THR 3) STR 4) BIND And if you are wondering why i am using a DX3E with this configuration, i am modifying my DX3E to have the ability to control front/rear motor bias. Last edited by Gat714; 10-31-2010 at 04:20 PM. |
Sponsored Links | |
10-31-2010, 03:44 PM | #2 |
Rock Stacker Join Date: May 2010 Location: N/A
Posts: 87
|
You can wire the bec to power the receiver or the servo. It doesn't matter which if you stay under 6v. If you plan on going over 6v you need to make sure your rx can handle it. Most don't like more than that, tho some people will argue that point. As far as where you plug the esc's in I would say the thr and aux ports. I do not know how you plan to run this set up tho. I was not aware you could mix the aux and thr channels on the radio you are using. The bec will plug into the bind port on that rx if I'm not mistaken. Good luck hope this helps
|
10-31-2010, 04:18 PM | #3 |
RCC Addict Join Date: Jun 2009 Location: QLD, Australia
Posts: 1,512
|
You will have to Y harness the two ESC to the THR channel. That is unless you want rear throttle either nothing or flat out forward or reverse The BEC in BIND and servo in STR. Kieren |
10-31-2010, 04:19 PM | #4 |
Quarry Creeper Join Date: Oct 2010 Location: Clovis, NM
Posts: 341
|
This is what i am planning to do with my DX3E... Feeler - DX3E hacked for Dual-ESC MOA Proportional DIG applications |
10-31-2010, 04:55 PM | #5 |
I wanna be Dave Join Date: Dec 2008 Location: Madrid, IA
Posts: 2,015
|
for that u put them in the throttle and aux ports
|
| |