12-28-2010, 12:34 AM | #1 |
Pebble Pounder Join Date: Oct 2010 Location: florida
Posts: 138
| dx6i mixing
I am trying to run dual esc's and I'm using a dx6i, but when I set up the mixing and turn it on it doesn't mix. Anyone have suggestion or had this problem before? Thanks
|
Sponsored Links | |
12-28-2010, 12:39 AM | #2 |
Quarry Creeper Join Date: Dec 2009 Location: Nacanowhere Texas
Posts: 494
|
I was having some problems at first with mine also. What are your mixes set at? Can you take some pics and post them up.
|
12-28-2010, 12:14 PM | #3 |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
|
Yea tell us what you have set...The best way to troubleshoot the setup is to look at the monitor screen so you can see what is going on.
|
12-28-2010, 12:42 PM | #4 |
On the lookout for Rocks Join Date: Mar 2006 Location: Monroe, Louisiana
Posts: 3,711
| |
12-28-2010, 03:38 PM | #5 |
Quarry Creeper Join Date: Jan 2009 Location: Truckee
Posts: 206
|
No camera,my mix1 screen reads, thro rudd act on the top line.Second line rate L +100% R+100%.Line three SW GEAR Trim Inn. Throtle Rudder mix activated,at 100% left and right + and it's turned on and off with the gear switch.You can assign it to a couple different switches. I have my trim innibited not shure why?
|
12-28-2010, 04:40 PM | #6 |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
| The trim inhibit is so that trims you apply to the master channel wont carry over to the slave...It just makes it easier to get everything trimmed in since you will be turning the mix on and off. Your setup is weird, why mix to rudder rather than elevator? It would normally read: Throttle--->elevator U 100% D 100% Whatever switch you want to use to turn it on and off. A cool trick is if you go U90% D110% then you will have overdrive on the axle moving forward with no right stick input, you may have to mess with the numbers to get it dialed in to where you like it but it should help keep the suspension sucked down. |
12-28-2010, 08:37 PM | #7 |
Pebble Pounder Join Date: Oct 2010 Location: florida
Posts: 138
|
My screen looks like this Elevator. Throttle. ACT Rate D+ 125. U+ 125 SW on. Trim ACT I don't know why it won't work. And I have tried it with Throttle controlling Elevator. |
12-28-2010, 10:06 PM | #8 | |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
| Quote:
It can be very confusing to get all the switches in the correct position at least for me, make sure that your switches are all in the correct positions. What does the monitor screen show when you work the throttle? | |
12-28-2010, 10:23 PM | #9 |
Pebble Pounder Join Date: Oct 2010 Location: florida
Posts: 138
|
Thank you veryy much! I mixed ele to rudd, and I'm gettin it worked out. |
12-28-2010, 10:42 PM | #10 |
Pebble Pounder Join Date: Oct 2010 Location: florida
Posts: 138
|
I got the mixing worked out. The only problem now is that it keeps loosing bind |
| |