Punk dig problem
 

So I searched and couldn't find anything so here it goes! I set up my punk dig wi an fxr and my dx3r. I haven't changed any of the adjustments on the radio except making the "E" switch my aux switch. My problem is when I use the the rear dig it works fine, and when I'm in 4wd it works fine. Now when I go to do front dig , I get 4wd again, any ideas? Thanks again!!

You have it set as "AUX 3P" correct??

Yup!
The function itself works fine but when I go for front dig it stays in 4wd

Travel for that channel set to 100% for both high and low?? Trim set to zero for that channel?

You bet! Still same problem

If you switch Motor 1 and Motor 2 leads, does the problem follow the motor?

Do you hear a nice click when you switch to the side that isnt working? Does the LED change colors?

I do not get a click but the led does change according to the commands I give

Sounds like the relay for the front motor isnt working and is staying on!!! Email punk and they should send you a replacment

Done "thumbsup" kinda sucks that it didn't work straight out of the box but that's more than fine I know complications happen I'm not upset with it at all

Right out of the box mine never got power to thr front motor, posative pole had 0 voltage. I sent it off about a week ago.

Hopefully I get a quick response from them on that!

If I remember correctly the guy behind punk dig works from his house so who knows what the normal business hours are...

Yep, normal business hours for Robin are spent at his 9-5 job....where he gets terrible phone reception.

Ya hopefully I get a response today on it! If it is just a defect hopefully I can send it in or get sent a new one!

It's also possible that one of the diodes is bad. I got a used Punk with busted diodes a while back and the light would change, but there was no Click and the motors stayed on regardless of the position. I soldered on some new diodes and it seemed to fix the problem.

However, if I had gotten the Punk new, then I would have sent it to him for the repair.

I never got a response from him on mine when I sent it back for repair (my fault:oops:) it showed up in the mail a little over a week later fixed... NO CHARGE! Robin really stands behind his product!"thumbsup"

Good to hear! Did you contact him first and talk to him or did you just send it right in?

You may try calling Mike Mann at Hobbytown Concord, 925-685-3802. He may be able to point you in the right direction and get you results"thumbsup"

Funny you should say that seeing as I work there!"thumbsup" I was just looking to see if anyone had input until next time I'm working (Thursday) so I could get the truck running for the course!