01-18-2011, 12:18 PM | #1 |
Pebble Pounder Join Date: Jan 2011 Location: Bakersfield,Ca
Posts: 104
| Bad BEC ?
I have a CC Bec on my LNC,had it wired direct to my 985mg servo and for the first 8-10 packs everything worked great,then I started noticing alot of glitching under load from the steering servo,then it started turning the steering to the left under load while glitching.So I plugged it into the reciever and the motor started glitching under load (to the point you can't drive it).So I bypassed the Bec & went back to stock-all ok.I watched the green light on the bec & it always stayed solid green.Here are the specs: LNC w/stock rtr electronics 985mg servo titan 21 motor losi 2s lipo packs Bec set at 6v Any ideas appreciated ! |
Sponsored Links | |
01-18-2011, 02:29 PM | #2 |
Newbie Join Date: Oct 2009 Location: Bakersfield
Posts: 16
|
I have the same set up as you except my CC BEC is wired directly to a Hitec 9755. I've had zero problems. But if it made the motor jitter when you plugged it into your receiver then I'd think it has to be the BEC. I'd contact Castle, I believe they have a repair or replace program at discounted pricing. Good Luck! |
01-18-2011, 02:34 PM | #3 |
Pebble Pounder Join Date: Jan 2011 Location: Bakersfield,Ca
Posts: 104
|
Yeah,just talked to them they are going to swap it out do to being less than 30 days old,great people to deal with.Thanks for the reply!
|
| |