Goat 3s/Brushed? I have a chance to pick up a goat 3s for 80$ after a fresh rebuild, because somebody thought it was water proof. I would like to run a brushed set up is this a good deal? Are the glitching problems mainly with brushless motors? My rig is an ax-10 comp based crawler with stock gears in the building stages moving into electronics. Thanks for any input. |
It will work with brushed motors. I think the limit is 33 turn. |
I am worried about the glitching issues that I've heard about, but it was with brushless motors is it different with brushed? I just like to get the 3s capability for a little cheaper. |
good luck with the goat 3s i just sent mine back for glitching i tried two different motors still wont work right if i was you i would get a TEKIN "thumbsup" |
All times are GMT -6. The time now is 08:40 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com