| |
02-10-2011, 01:09 PM
| #1 |
| Pebble Pounder Join Date: Sep 2008 Location: philly
Posts: 129
|  how to run my fan
i have an ezrun 35 a esc and the fan is only rated for 7.4 volts, i am running 11.1 3c lipos and have seen that some people plug the fan into there reciver, which input do i use to do this, or do i need a high volt fan. thanks |
|  |
| Sponsored Links | |
| | |
|
02-10-2011, 01:22 PM
| #2 |
| RCC Addict Join Date: May 2008 Location: Chicago/Bloomington
Posts: 1,505
|
Do you run a BEC to the RX? Then you plug it into the RX. Do you have the BEC feeding the servo then plug it into the ESC if the ESC is feeding the RX. |
|
| |
|
02-10-2011, 05:13 PM
| #3 |
| Rock Crawler Join Date: May 2009 Location: Queensland, Australia
Posts: 610
|
Better question is do you need a fan. If you are running the ESC in a crawler depending of the Kv of the motor you most likely dont need a fan. I'm running a EZRUN in my scaler that weighs in at around 2.7kg (6lbs) on 3s, no fan the hottest the esc has ever gotten is 45*c (113*f) and that was on a day that it was 35*c (95*f) ambient. |
|
| |
 |
| |
Linear Mode
