rc4wd bulldog 9300 winch problems
 

I bought a rc4wd bulldog 9300 winch. It works great, but after running the truck for a while, they winch creeps out. I have centered the trim on radio, and the trim on the winch controller. I think that the problem is the controller. It is very touchy. How do I get it to stay centered?

This is a common problem on most winches. Wantasummit makes a solder in controller that fixes this problem. I believe it works on this winch also. See vendors section/electronics

If you decide to replace your controller, I make a few different versions.

• This one will run your winch if your BEC outputs up to 6 volts: http://www.rccrawler.com/forum/vendors-electronics/286854-no-drift-winch-controller-using-3-position-transmitter-channel.html
• This one if you want to run a higher voltage to your winch: http://www.rccrawler.com/forum/vendors-electronics/297260-updated-march-15-2012-higher-voltage-winch-controller.html
• This one if you want to operate your winch using a remote with only a two position channel: http://www.rccrawler.com/forum/vendors-electronics/286855-winch-controller-radio-2-position-third-channel.html

I just got the bulldog 9300 winch and when i first pluged it in it creeps out about a fourth the speed as it does when it is soposed to come in out. Im using the spectrum dx3e with an 11.1v 5400mah lipo battery. what do u sugest i do?

If you just got it, maybe take it back to the place you bought it from or contact them about warranty. If it is used and you want to try a new controller, I think you know what I would suggest.

x2.