extend bec wires? I need a few more inches from my BEC wires in order to mount the electronics where I want them. Can I just clip the red and black wires and solder in a few inches of wire to extend them? I tried a servo extension that I had but it didn't work... maybe it's bad or perhaps it didn't work because the rc4wd winch is a motor and not a servo? |
Extending them should be fine, just be sure to use the same, or very close to the same, gauge of wire. |
Quote:
Use same or larger sized wire (same or smaller "ga" number). As to your comment about it being a motor and not a servo, servo's have a motor in them, so basically the same.8) |
All times are GMT -6. The time now is 09:28 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com