hitech 7950 Ok just got a used hired 7950 installed it turned everything on centered it and now it goes full lock left.but maybe 3/4 to the right can't change endpoints to fix it though any ideas? |
Quote:
|
Sounds to me like the circuitry inside the servo is broken. Plug another servo into the same slot of the receiver and see if it is working right for you. If it does, it likely means that the first servo is broken. Probably a good doner to become a servo winch :mrgreen: |
ok so i have been messing with the radio even set the end point to 150 percent into the danger zone and it turns a little bit more but just isnt really there yet. so programer will be my next try i'll find someone hopefully. |
Quote:
|
Quote:
|
ok guys i figured it all out thanks a lot. |
Quote:
Hmmm....maybe you found the servo horn wasn't centered?? Nevermind......here...http://www.rccrawler.com/forum/elect...ch-thread.html post #685. |
All times are GMT -6. The time now is 08:32 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com