4pl glitch
 

This is on a wraith I just installed a cc bec everything works like it should when I go from stop to full throttle it sputters and the receiver goes from green to red to green to red but if I roll into it it does fine. Any ideas


From a misused and abused I phone

What mah & "C" rating is your pack?
Did it do this before you added the CC BEC?

http://img.tapatalk.com/aefca44c-f961-b051.jpg
This is what I put in and no it didn't glitch befor


From a misused and abused I phone

What mah & "C" rating is your pack?
What radio do you have?
What ESC?
Is your RX near the ESC or the BEC?

There have been some issues with a couple of ESC's & CC BEC's, I believe the RS running firmware V2.12 is one.

Don't know on the first I'm a noon at this
Futaba 4pl
Novak rooster crawler
Yes the esc is next to the rx but I've had no problems Befor and no the bec is not next to it


From a misused and abused I phone

Most packs will have a series of numbers on them, my 2.2 comp packs are:

3S 1350mah 45C

The 3S = # of cells
The 1350 = mah capacity (how long it will run)
The 45C = how fast the power can come out of the pack

You could try recalibrating the ESC to the RX, otherwise I'm stumped for now.

Make sure your red wire on the ecs is clipped"thumbsup"

Good idea, but I would remove it from the RX connector and tape it off.

thats gonna be a major problem right there. that, or theres a power wire by your antenna/signal wire.

Just got off work will try all suggestions and let ya know the results thanks for the help


From a misused and abused I phone

Ok red wire out check
Cc bec away from rx check
All wires were they should be check
Running and operational check
Still glitching check but not as bad
It's like the whole thing is loosing power even the lights flicker on and off


From a misused and abused I phone