Castle Creations 1/10 SV2 Sidewinder ESC dose any one know the brushed turn limit for this omot on 3 cell lipo i want to know if i can run a 19 x2 on this speed contole any help would be great thanks |
Re: Castle Creations 1/10 SV2 Sidewinder ESC Personally I wouldn't suggest using a 3S with any brushed motor and an SV2. I had three die on me with a 2s and mild 35-55 turn motors over the course of six months. But I have one powering a 3800kv 4 pole brushless that still works after almost a year, and it runs much cooler than the others running much less powerful brushed motors. |
Re: Castle Creations 1/10 SV2 Sidewinder ESC Quote:
as for your question...check the CC website...should say there |
Re: Castle Creations 1/10 SV2 Sidewinder ESC Ok thanks guys I went to the lhs and found out all I needed but personal exp is gladly appreciated |
Re: Castle Creations 1/10 SV2 Sidewinder ESC I dont know why people are having so many problems with them because I have 2 and they work flawlessly in both my rigs. They are great for the money, I wouldnt compare them to a BR-XL or MMP but I just picked up 2 more for $35 a piece from ebay brand new. |
Re: Castle Creations 1/10 SV2 Sidewinder ESC The brushed motor limit of the SV2 is listed at 19t (same as the original sidewinder). I've personally run a 19t on 3s, motor was stupid hot esc was about 65°c on the heat sink. I'm also not sure why so many people have had a bad run with SV2s, I've bought 6+ since they came out and only one has recently given up the ghost in mysterious circumstances. |
Re: Castle Creations 1/10 SV2 Sidewinder ESC Ok I stick with a 35 t on mine I was thinking on runnin a new 19x2 turn but I don't want to over heat it so ya thanks again keep them comin pls |
Re: Castle Creations 1/10 SV2 Sidewinder ESC Also a lot of the short course guys put a fan on top of the heatsink so that is an option if the esc is getting too warm. |
Re: Castle Creations 1/10 SV2 Sidewinder ESC Ok sweet thanks love the info |
Re: Castle Creations 1/10 SV2 Sidewinder ESC Quote:
|
Re: Castle Creations 1/10 SV2 Sidewinder ESC I was thinking tough truck |
Re: Castle Creations 1/10 SV2 Sidewinder ESC I bought 2 SV2's.... Wired them up. Hooked da 2S to do the programing on the feild card. And now one of them wont power up at all. I haven't even put this junk on a motor yet.... i can see I need to go another rout. The CC ESC's are not very good. From what I have seen. |
All times are GMT -6. The time now is 01:58 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com