RCCrawler Forums

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Electronics (http://www.rccrawler.com/forum/electronics/)
-   -   Tekin 13.5 no low end power? Help (http://www.rccrawler.com/forum/electronics/400728-tekin-13-5-no-low-end-power-help.html)

Jeepfixer1 09-01-2012 10:08 PM

Tekin 13.5 no low end power? Help
 
Hey fellow crawlateers, I was hoping you could help me with a question. I have a fairly heavy wraith with a mmp and Tekin redline 13.5 brushless. She used to be fairly mean but lately it seems like she had less and less grunt when bound up in the rocks. Now on the last run on flat ground in the grass if starting from a dead stop I have to pop the throttle to take off. Top end seems ok but bottom is crappy. I figured I have killed my little 13.5 (sound bagpipes here). It does run warm but not crazy hot unless I just didn't catch it when it did! I'm running 12/60 32p gears. Thanks for the advice. Ohh by the way if the motor is going bad do you typically just replace the rotor in a brushless motor doing this? Thanks again :)

benoj 09-02-2012 10:00 AM

It sounds like one of the windings in the stator are bad from binding it up. There is no reason to replace the rotor but the takins don't have replaceable stators like the novak ballistics so a new motor is likely in order


Sent from my iPad using Tapatalk

Jeepfixer1 09-02-2012 01:45 PM

Re: Tekin 13.5 no low end power? Help
 
Can you check that with a dmm, using an ohms test?

Skeld 09-02-2012 03:43 PM

Re: Tekin 13.5 no low end power? Help
 
You can not test with a dmm. The meter will show continuity in all directions. If you can see the windings look for one that has been hot(discolored).

RusT808 09-02-2012 05:10 PM

Re: Tekin 13.5 no low end power? Help
 
My 13.5 Tekin is the exact same. I will take mine apart and see if there is a discolored wind.

losikid 09-02-2012 05:32 PM

Re: Tekin 13.5 no low end power? Help
 
Check your sensor cable

RusT808 09-02-2012 05:35 PM

Re: Tekin 13.5 no low end power? Help
 
Quote:

Originally Posted by losikid (Post 3897761)
Check your sensor cable

I did. Tried 3 different ones, works with other motors and escs, but the Tekin still has no low end power.

JohnRobHolmes 09-03-2012 07:31 AM

Re: Tekin 13.5 no low end power? Help
 
Could be a demagged rotor. That is the one problem with the smaller roar style motors, if you bind it up and go too far on the throttle it can degauss the rotor. First I say look for discoloration on the winds, then you should have the rotor strength checked. If the winds burnt up you need a new rotor anyway.

Jeepfixer1 09-03-2012 08:33 AM

Re: Tekin 13.5 no low end power? Help
 
Is it worth New windings and rotor if needed or just buy new motor?

benoj 09-03-2012 11:29 AM

With a takin motor you are going to get a new motor as only the rotor would be easily replaceable


Sent from my iPad using Tapatalk

CHOPPERMECH11 09-04-2012 08:30 AM

Re: Tekin 13.5 no low end power? Help
 
I had the same motor in my wraith. I ended up damaging the motor. Mine is heavy as well. I sent it to tekin and the fixed it. then I bought a pro4 3300KV. Night and day power

Jeepfixer1 12-22-2012 10:15 AM

Re: Tekin 13.5 no low end power? Help
 
I bought the pro 4 cause I have no patience. I am sold on 4pole motors. Me like torque :ror: I sold the redline to a bud and he sent it to Tekin and they warrantied the rotor. I magnet had bit the dust. Thanks Tekin for the pro4, I love it and my buddy I'm sure will love the 13.5."thumbsup"


All times are GMT -6. The time now is 04:39 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com