10-11-2012, 05:44 PM | #1 |
RCC Addict Join Date: Feb 2010 Location: New Jersey shore
Posts: 1,482
| ae 2 lipo cut off
i read these are set to auto.. my charger is saying. low voltage.. there a way to check the lipo cut off? also is my lipo shot?? tried changing a few times same thing every time.. thanks
|
Sponsored Links | |
10-11-2012, 05:59 PM | #2 |
I wanna be Dave Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
| Re: ae 2 lipo cut off
They are set to auto lipo but only 3v per cell. Likely your battery is out of balance and while it is 3v per cell when measured at the battery connector if you measured each cell one or more would be under. Bump the LVC voltage up to 3.2-3.3 volts per cell and always balance charge them. |
10-11-2012, 06:16 PM | #3 | |
No idea what I'm doing Join Date: Oct 2008 Location: Underground, CO
Posts: 4,529
| Re: ae 2 lipo cut off Quote:
Castle Creations Castle Link USB Interface Adapter (same as HPI #100573) #010-0005-00*-*Speed Controllers and accessories*-*-Electronics*-*The Crawlers Store LLC | |
10-11-2012, 06:25 PM | #4 |
RCC Addict Join Date: Feb 2010 Location: New Jersey shore
Posts: 1,482
| Re: ae 2 lipo cut off
its a 7.4 5000 pack.. got it to charge for a bit on the nimh setting. just to get some power into it.. not ever for a minute.. went back to lipo balance.. charger says its up by 8.38.. keep saying voltage error....
|
10-11-2012, 06:26 PM | #5 |
RCC Addict Join Date: Feb 2010 Location: New Jersey shore
Posts: 1,482
| Re: ae 2 lipo cut off
thanks ill try the castle link
|
10-11-2012, 07:30 PM | #6 |
RCC Addict Join Date: Feb 2010 Location: New Jersey shore
Posts: 1,482
| Re: ae 2 lipo cut off
starting to think my charger is messed up.. charged one pack good.. 5000 still low voltage and a new never used 7.4 4000 pack low voltage.. dammit
|
10-11-2012, 08:43 PM | #7 |
RCC Addict Join Date: Jun 2011 Location: Gilbert, AZ
Posts: 1,634
| Re: ae 2 lipo cut off
Something funny is going on. My AE-2 with the auto lipo cut-off usually discharges into the 3.2-3.3 range, never had a problem charging afterwards. If you have a multimeter check the voltage of the pack that way.
|
10-12-2012, 05:03 AM | #8 | ||
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Re: ae 2 lipo cut off Quote:
Quote:
What exactly is the error message? What charger? I've had times where the pack was OK, but a cell was really low or the balance wire was broken. If you are balance charging, unplug the balance board and try just charging on LiPO. Do a balance charge later. PS, are you going to the Dez comp Sunday? I will have a Castle Link if you need to try it. | ||
10-12-2012, 07:34 AM | #9 |
RCC Addict Join Date: Nov 2008 Location: Bunnell, Fl.
Posts: 1,292
| Re: ae 2 lipo cut off
Sounds like your charger may be crapping out. I just had a similar issue with a Novak charger that I use for my Nimh packs, it wouldn't even charge some brand new packs I got. I had to get another charger.
|
10-12-2012, 09:48 AM | #10 |
RCC Addict Join Date: Dec 2011 Location: Raleign
Posts: 1,439
| Re: ae 2 lipo cut off
When you get your battery straightened out and get a programmer set your LVC manually for the packs you're going to run. I have mine set at 6.8 on my two AE-2's. Auto lipo doesn't work for crap on those ESC's. Not sure why because on my Sidewinders it's very reliable.
|
10-12-2012, 10:22 AM | #11 |
Rock Crawler Join Date: Nov 2011 Location: Paradise, ca
Posts: 890
| Re: ae 2 lipo cut off
I just ran an 800 and a 1600 miliamp 2s through my ae-2 and it shut the voltage off at 6.4 volts to both and they charge up perfect. Its a good possibility that its the charger your using is going out
|
ae 2 lipo cut off - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lipo cut off | bowtieuser | Newbie General | 8 | 01-31-2012 06:39 AM |
Lipo Cut off | spiderxx | Newbie General | 2 | 08-25-2011 09:30 PM |
lipo cut off | big daddy smokes | Newbie General | 3 | 08-25-2011 03:28 PM |
Lipo cut off | Losi man | Losi Mini-Rock Crawler | 8 | 03-29-2010 01:39 AM |
| |