Tekin 35t pro handwound on 2s? Like the title states i'm wondering if I can run a 2s on this particular motor. I have searched and can't find any specs. I know I can only run a 3s minimum in my HD version. Any input is appreciated. |
Re: Tekin 35t pro handwound on 2s? The voltage limit is on the upper end not lower. I probably would not run more than 3s through it. But it should run fine on 2s. |
Re: Tekin 35t pro handwound on 2s? 3s no problem, just more frequent rebuilds.....4s is usually fine too, but even more frequent rebuilds......some nuts run 5s, works but plan on rebuilding daily. :) Later EddieO |
Re: Tekin 35T pro handwound on 2S? As stated you're fine, I ran quite a few 3S LiPO packs through the same motor. Keep an eye on it.....no real issue. Never tried more than a 3S LiPO through it though. More voltage/load, more maintenance.8) |
I run the Tekin handwound 35t in my 8.5 pound G6 rig. 3s all day long with no problems at all. Just did the first rebuild after 5 G6 runs. About 2 or 3 hours per run on average. |
All times are GMT -6. The time now is 04:33 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com