Bec question Ok I have put plenty of bec's in and all my rigs have them but I picked up a tf2 and I know I need the power for my steering servo but I want to run a 3 cell and it says a BEC is required. My question is the shift servo. Will have a problem if I leave that powered by the receiver power or should the BEC power the two servos? Thanks!! |
Re: BEC question Shift/dig servos are usually very low torque (maybe ~100inoz) thus, are covered by the ESC BEC. Use the internal BEC to cover the steering servo if it's a higher torque. If you wire the external BEC through the RX (not my 1st choice), it should be fine with both servos. |
Re: Bec question Ok thanks. Why do they say a BEC is required with a 3 cell? |
Re: Bec question Quote:
|
Re: Bec question Oh ok thanks!! |
All times are GMT -6. The time now is 01:28 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com