My 1/6th scale servo problem solved
 

HS-900SGS
Operating Speed (11.1V):0.20 sec/60° at no load
Operating Speed (14.8): 0.15 sec/60° at no load
Stall Torque (11.1V): 902 oz/in. (65 kg.cm)
Stall Torque (14.8V): 1208 oz/in. (87 kg.cm)

servo city link VV
HS-900SGS Servo

I already assigned enough room to fit a 1/4 scale servo and was possible going to use one if my Ti geared servos to steer my 1/6 Rock Racer but WOW this thing is awesome

ok its really expensive also but this rig is getting pretty wild !!"thumbsup"

my plan is to use a 775 and an old EVX esc for now and eventually use a set up like a Novak Diablo so I'l have the voltage available ( already picked up lipo's for the brushless set up and have a ton of good standard batteries

I might have to get 2 of them, the other for my 72" catamaran ( yea 1/6th also )

Re: My 1/6th scale servo problem solved
 

Imagine that converted to a 4S/1200 oz winch! :twisted:



:shock::shock::shock::shock: and :shock:

Da heck?.... droppin' that on us when I'm all out of jawdrop smileys........

Re: My 1/6th scale servo problem solved
 

it would be like a slingshot... lol !!

sorry 'bout your jaw, yea I got a 72" offshore catamaran made by Capricorn Boats (not even sure if they still exist)

just like this one V
72inch capricorn rc boat - YouTube

Its going thru a slow re-paint & re-build/ electric conversion. Going to convert to single rudder also .

want to go with the equivilant of 2 Castle 2028's but water-cooled and run 36volts, that will give me 20 hp and enough rpm to get over 100mph...... I hope

just for sheer strength I scratch built my struts, rudders and brackets all out of 316 stainless steel and steer it with aircraft rod ends :)