how do you install cc bullet connectors
 

I just recently picked up a brushless motor that needs bullet connectors I have some on the way but my question is how exactly do I attach them to the motor wires? Every motor I've ever bought off here had them already installed so I've never done it myself.

Thanks,
Kenneth

Re: how do you install cc bullet connectors
 

I'm sure a quick search on YouTube would show you.

Fill the shallow end up with solder and stick the wire in. Pretty simple.

Re: how do you install cc bullet connectors
 

cover the tip of the wire with solder get one of those holders from radio shack with the clips to hold the wire heat the connector up with the wire in it and melt more solder into that little hole thats in the connector...then heat shrink the lower part....done

Re: how do you install cc bullet connectors
 

I tried bubble gum once but it didn't work out very well.
Solder is the way to go. "thumbsup"

I tin the wire (heavy solder)
and then stick it in the hole.
and then hold the solder up to the wire/hole and let it flow to the hole fills up.

Re: how do you install cc bullet connectors
 

I drill a hole in a 2x4 to make a jig to hold the bullet connector.

1) Tin the wire.
2) Fill the bullet connector with solder and then put the wire into the bullet connector/molten solder. Take the heat way and then let it cool down.
3)After it is cool then put on the heat shrink.

Here is video:

How to Solder Bullet Connectors to Brushless Motors and ESC - YouTube

http://www.youtube.com/watch?v=B9yY9Kk4bEAhttp://