|
| LinkBack | Thread Tools | Display Modes |
07-09-2013, 11:35 AM | #1 |
RCC Addict Join Date: Apr 2012 Location: Land of 10,000 Lakes
Posts: 1,460
| Hitec hs5646wp twitching
So I drove my truck through some water and fried the receiver. I water proofed my spare and installed it. I put it in and it works, but when I try to steer to the left after steering from the right, it will twitch and slowly twitch its way left. is it a binding issue? is a bec needed? Btt: Reedy 20c 3s 3200MaH Tx/Rx: Flysky fs-gt3b ESC: Castle Sv2 Motor: Traxxas 12t 550 Servo: Hitec hs5646wp |
Sponsored Links | |
07-09-2013, 11:43 AM | #2 |
In the band for now. Join Date: Sep 2012 Location: roselle
Posts: 350
| Re: Hitec hs5646wp twitching
for that little servo you probably wont need a BEC but it cant hurt, only 20 bucks and well worth it. may even stop the gliching
|
07-09-2013, 11:43 AM | #3 |
RCC Addict Join Date: Mar 2007 Location: Turn the mayflower around.. it will never work
Posts: 1,588
| Re: Hitec hs5646wp twitching
Ok...... Here we go...... You just posted a motor issue and left that info out..... Sounds like you have a lot more of an issue than just the motor or just the servo..... Ya need to re group, and start at the top. First the 3channel rx from flysky has been said to be water proofed from factory. I have had no issues with mine near water. So un plug everything and check through each component. Make sure rx is lighting up it is bound.... Then go and check calibration on esc..... Then see if motor runs. If not check what Eddie said and run small batteries to motor and see if it runs. Or check with volt meter. Other thing is , is there a bec involved? Check servo for water inside..... Yadda Yadda. Many things can happen due to water. Starting at the top will find you the component that is fried or giving you issues. Also never used that servo myself but have heard that its really not all that good. Not sure if its just the 180 oz or internals. I use 7954 and 7950s and water proof myself. Last edited by JokersWild; 07-09-2013 at 11:59 AM. |
07-09-2013, 12:09 PM | #4 |
RCC Addict Join Date: Apr 2012 Location: Land of 10,000 Lakes
Posts: 1,460
| Re: Hitec hs5646wp twitching
Alright, I took apart the servo, and there was no water. I put some marine grease in it and it's not twitching any more. but the motor is still not working.
|
Hitec hs5646wp twitching - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Twitching? | jessecuster | Losi Micro-Rock Crawler | 18 | 05-18-2011 05:38 PM |
twitching?!! | ninetwofiveRC | Electronics | 2 | 01-05-2011 05:48 PM |
Twitching | kla32 | Electronics | 6 | 03-28-2010 06:30 PM |
twitching | outoforder | Newbie General | 4 | 05-05-2009 05:53 AM |
twitching in reverse only | sooperarthur | Axial AX-10 Scorpion | 2 | 08-25-2008 06:44 PM |
| |